NETGEAR FVS336Gv3 Reference Manual page 240

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
Note: Inbound LAN WAN rules take precedence over inbound DMZ WAN rules.
When an inbound packet matches an inbound LAN WAN rule, the VPN
firewall does not match the packet against inbound DMZ WAN rules.
WARNING:
Make sure that you first configure the IPv4 WAN routing mode (see
Manage the IPv4 WAN Routing Mode
configure custom firewall rules. If you change the IPv4 WAN routing
mode, all DMZ WAN inbound rules revert to default settings.
The following sections provide information about adding DMZ WAN inbound service rules:
• Add an IPv4 DMZ WAN Inbound Rule
• Add an IPv6 DMZ WAN Inbound Rule
Add an IPv4 DMZ WAN Inbound Rule
The following procedure describes how to add an IPv4 DMZ WAN inbound rule.

To add an IPv4 DMZ WAN inbound rule:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Security > Firewall > DMZ WAN Rules.
The DMZ WAN Rules screen displays the IPv4 settings.
on page 30) before you
Customize Firewall Protection
240