Configure The Ipv6 Internet Connection And Wan Settings; Ipv6 Network - NETGEAR FVS336Gv3 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
5. (Optional) Configure auto-rollover and failure detection. By default, the WAN interfaces
are configured for primary (single) WAN mode. You can enable auto-rollover and configure
the failure detection settings.
These tasks are described in
6. (Optional) Configure advanced WAN options. If necessary, change the factory default
MTU size, port speed and duplex settings, advertised MAC address of the VPN firewall, and
WAN connection type and corresponding upload and download connection speeds. These
are advanced features, and you usually do not need to change the settings.
These tasks are described in
Chapter 2.

Configure the IPv6 Internet Connection and WAN Settings

The following sections provide information about configuring the IPv6 Internet connection
and WAN settings:
•

IPv6 Network

• Manage the IPv6 Routing Mode
• Use a DHCPv6 Server to Configure an IPv6 Internet Connection Automatically
• Manually Configure a Static IPv6 Internet Connection
• Manually Configure a PPPoE IPv6 Internet Connection
IPv6 Network
The nature of your IPv6 network determines how you must configure the IPv6 Internet
connections:
• Native IPv6 network. Your network is a native IPv6 network if the VPN firewall has an
IPv6 address and is connected to an IPv6 ISP and if your network consists of IPv6-only
devices. However, because we are in a IPv4-to-IPv6 transition period, native IPv6 is not
yet common.
• Isolated IPv6 network. If your network is an isolated IPv6 network that is not connected
to an IPv6 ISP, you must make sure that the IPv6 packets can travel over the IPv4
Internet backbone; you do this by enabling automatic 6to4 tunneling (see
Automatic Tunneling
• Mixed network with IPv4 and IPv6 devices. If your network is an IPv4 network that
consists of both IPv4 and IPv6 devices, you must make sure that the IPv6 packets can
travel over the IPv4 intranet; you do this by enabling and configuring ISATAP tunneling
(see Manage ISATAP Automatic Tunneling
Note: A network can be both an isolated IPv6 network and a mixed network
with IPv4 and IPv6 devices.
Configure Auto-Rollover for IPv6 Interfaces
Managing Advanced WAN Options
on page 101).
Configure the IPv6 Internet and WAN Settings
87
on page 66 in
on page 103).
on page 109.
Manage 6to4