NETGEAR FVS336Gv3 Reference Manual page 200

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
8. Enter the settings as described in the following table.
Setting
DMZ Port Setup
Select the Yes radio button to configure the DMZ port settings. Complete the following fields:
• IPv6 Address. Enter the IP address of the DMZ port. Make sure that the DMZ port IP address, LAN
port IP address, and WAN port IP address are in different subnets. The default IP address for the
DMZ port is fdff::1.
• Prefix Length. Enter the IPv6 prefix length, for example, 10 or 64. The default prefix length for the
DMZ port is 64.
Note: By default, the DMZ port is disabled. After you configure the DMZ port, you can select the No radio
button to disable the DMZ port without losing the DMZ configuration.
DHCPv6 for DMZ Connected Computers
DHCP Status
DHCP Mode
Description
Enable the DHCPv6 server by selecting Enable DHCPv6 Server from the
DHCP Status menu.
The default menu selection is Disable DHCPv6 Server.
From the DHCP Mode menu, select Stateful.
The IPv6 clients obtain an interface IP address, configuration information such
as DNS server information, and other parameters from the DHCPv6 server.
The IP address is a dynamic address.
For stateful DHCPv6, you must add one or more IPv6 address pools (see
an IPv6 DMZ Address Pool
Configure the IPv6 LAN Settings
200
on page 201).
Add