NETGEAR FVS336Gv3 Reference Manual page 221

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
Table 6. Inbound rules overview (continued)
Setting Description
DMZ Users The settings that determine which DMZ computers on the DMZ
network are covered by this rule. The options are as follows:
•
•
•
Note:
apply when the WAN mode is NAT because your network
presents only one IP address to the Internet.
QoS Profile The priority assigned to IP packets of this service. The priorities
are defined by Type of Service in the Internet Protocol Suite
standards, RFC 1349. The QoS profile determines the priority of
a service, which, in turn, determines the quality of that service for
the traffic passing through the firewall.
The VPN firewall marks the Type of Service (ToS) field as
defined in the QoS profiles that you create. For more information,
see
on page 295.
Note:
QoS profiles. That is, if you want to use QoS for IPv4 traffic, you
must create QoS profiles. For IPv6 traffic, the VPN firewall does
provide QoS profiles but you cannot change them. A QoS profile
becomes active only when you apply it to a nonblocking inbound
or outbound firewall rule.
Note:
time, the performance of the VPN firewall might be affected
slightly.
Note:
Any. All computers and devices on your DMZ network are
covered by this rule.
Single address. Enter the required address in the Start field
to apply the rule to a single computer on the DMZ network.
Address range. Enter the required addresses in the Start
and Finish fields to apply the rule to a range of DMZ
computers.
For IPv4 DMZ WAN inbound rules, this field does not
Manage Quality of Service Profiles for IPv4 Firewall Rules
For IPv4 traffic, the VPN firewall does not provide default
When you apply a QoS profile to a firewall rule for the first
QoS profiles do not apply to LAN DMZ rules.
Customize Firewall Protection
221
Inbound Rules
DMZ WAN rules
LAN DMZ rules
IPv4 LAN WAN rules
IPv4 DMZ WAN rules