NETGEAR FVS336Gv3 Reference Manual page 279

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Security > Firewall > IGMP.
The IGMP screen displays. The following figure shows one alternate network as an
example.
7. Select the Yes radio button.
8. If you configured load balancing (see
Binding for IPv4 Interfaces
the upstream interface (WAN1, the default, or WAN2) to which multicast traffic must be
bound.
Only a single interface can function as the upstream interface.
Note: When you change the WAN mode to load balancing while multicast
pass-through is already enabled, multicast traffic is bound to the active
interface of the previous WAN mode.
9. Click the Apply button.
Multicast pass-through is enabled.
10. If the interface to which multicast traffic is bound is configured for PPPoE or PPTP, you must
add the multicast source address to the Alternate Networks table:
a. In the Alternate Networks section, below the table, enter the following settings:
• IP Address. Enter the multicast source IP address.
• Subnet Mask. Enter the subnet mask for the multicast source address.
Configure Load Balancing Mode and Optional Protocol
on page 49), from the Bind Upstream Interface menu, select
Customize Firewall Protection
279