Testing The Connection; Creating A Vpn Connection: Netgear Vpn Client To Fvs338 - NETGEAR ProSafe FVS338 Reference Manual

Reference Manual for the ProSafe VPN Firewall 50 FVS338
Enter the LAN IP address and subnet mask of the remote FVX538.
8.
Figure 8-10: LAN IP address and subnet mask of remote FVX538
Click Next.
9.
Click Done to create the 'to_fvx' IKE and VPN policies.
10.

Testing the Connection

From a PC on either firewall's LAN, try to ping a PC on the other firewall's LAN. Establishing
1.
the VPN connection may take several seconds.
For additional status and troubleshooting information, view the VPN log and status menu in
2.
the FVX538 or FVS338.

Creating a VPN Connection: Netgear VPN Client to FVS338

This section describes how to configure a VPN connection between a Windows PC and the
FVS338 VPN firewall.
Using the FVS338's VPN Wizard, we will create a single set of policies (IKE and VPN) that will
allow up to 50 remote PCs to connect from locations in which their IP addresses are unknown in
advance. The PCs may be directly connected to the Internet or may be behind NAT routers. If more
PCs are to be connected, an additional policy or policies must be created.
Each PC will use Netgear's VPN Client. Since the PC's IP address is assumed to be unknown, the
PC must always be the Initiator of the connection.
8-8
January 2005
Virtual Private Networking