NETGEAR FVS336Gv3 Reference Manual page 409

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
9. In the tree list pane of the Configuration Panel screen, right-click the GW_ModeConfig
authentication phase name and select New Phase 2.
10. Change the name of the IPSec configuration (the default is Tunnel):
a. Right-click the IPSec configuration name.
b. Select Rename.
c. Type Tunnel_ModeConfig.
d. Click anywhere in the tree list pane.
Note: This is the name for the IPSec configuration that is used only for the
VPN client, not during IPSec negotiation. You can view and change
this name in the tree list pane. This name must be a unique name.
The IPSec pane displays in the Configuration Panel screen, with the IPSec tab selected
by default:
11. Specify the settings that are described in the following table.
Setting
VPN Client address
Address Type
Set Up Virtual Private Networking With IPSec Connections
Description
This field is masked out because Mode Config is selected. After an IPSec
connection is established, the IP address that is issued by the VPN firewall displays
in this field (see Test the Mode Config Connection
From the menu, select Subnet address.
409
on page 411).