Use The Ipsec Vpn Wizard For Client And Gateway Configurations - NETGEAR FVS336Gv3 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
WAN load balancing: FQDN required or optional for VPN
Multiple WAN port model
Rest of VPN firewall
VPN firewall
functions
Figure 7. WAN load balancing: FQDN required or optional for VPN
The following table summarizes the WAN addressing requirements (FQDN or IP address) for
a VPN tunnel in either dual WAN mode.
Table 7. IP addressing for VPNs in dual WAN port systems
Configuration and WAN IP Address
VPN Telecommuter
(client to gateway)
VPN Gateway-to-Gateway
(gateway to gateway)
VPN Telecommuter
(client to gateway through a
NAT router)
a. After a rollover, all tunnels must be reestablished using the new WAN IP address.
Use the IPSec VPN Wizard for Client and Gateway
Configurations
You can use the IPSec VPN Wizard to configure multiple gateway or client VPN tunnel
policies.
The following sections provide information about how to create IPSec VPN connections with
the IPSec VPN Wizard and NETGEAR ProSAFE VPN Client software:
• IPSec VPN Wizard Overview
• View the IPSec VPN Wizard Default Values
• Create an IPv4 Gateway-to-Gateway VPN Tunnel with the Wizard
• Create an IPv6 Gateway-to-Gateway VPN Tunnel with the Wizard
• Create an IPv4 Client-to-Gateway VPN Tunnel with the Wizard
Load
WAN port balancing
control
functions
Rollover Mode
Fixed FQDN required
Dynamic FQDN required
Fixed FQDN required
Dynamic FQDN required
Fixed FQDN required
Dynamic FQDN required
Set Up Virtual Private Networking With IPSec Connections
WAN 1 port
Internet
WAN 2 port
FQDN required for dynamic IP addresses
FQDN optional for static IP addresses
a
Load Balancing Mode
FQDN allowed (optional)
FQDN required
FQDN allowed (optional)
FQDN required
FQDN allowed (optional)
FQDN required
337