NETGEAR FVS336Gv3 Reference Manual page 652

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
PPP Logs
This section describes the WAN PPP connection logs. The PPP type can be configured from
the web management interface (see
on page 39).
• PPPoE idle time-out logs
Table 25. System logs: WAN status, PPPoE idle time-out
Message
Explanation
Recommended action
Manually Configure a PPPoE IPv4 Internet Connection
Nov 29 13:12:46 [FVS336Gv3] [pppd] Starting connection
Nov 29 13:12:49 [FVS336Gv3] [pppd] Remote message: Success
Nov 29 13:12:49 [FVS336Gv3] [pppd] PAP authentication succeeded
Nov 29 13:12:49 [FVS336Gv3] [pppd] local IP address 50.0.0.62
Nov 29 13:12:49 [FVS336Gv3] [pppd] remote IP address 50.0.0.1
Nov 29 13:12:49 [FVS336Gv3] [pppd] primary DNS address 202.153.32.3
Nov 29 13:12:49 [FVS336Gv3] [pppd] secondary DNS address
202.153.32.3
Nov 29 11:29:26 [FVS336Gv3] [pppd] Terminating connection due to lack
of activity.
Nov 29 11:29:28 [FVS336Gv3] [pppd] Connect time 8.2 minutes.
Nov 29 11:29:28 [FVS336Gv3] [pppd] Sent 1408 bytes, received 0 bytes.
Nov 29 11:29:29 [FVS336Gv3] [pppd] Connection terminated.
Message 1: PPPoE connection started.
Message 2: Message from PPPoE server for correct login.
Message 3: Authentication for PPP succeeded.
Message 4: Local IP address assigned by the server.
Message 5: Server side IP address.
Message 6: The primary DNS server that is configured on the WAN ISP
Settings screen.
Message 7: The secondary DNS server that is configured on the WAN ISP
Settings screen.
Message 8: The PPP link has transitioned to idle mode. This event occurs
if there is no traffic from the LAN network.
Message 9: The time in minutes for which the link is up.
Message 10: Data sent and received at the LAN side while the link was up.
Message 11: PPP connection terminated after idle time-out.
To reconnect during idle mode, initiate traffic from the LAN side.
System Logs and Error Messages
652