NETGEAR FVS336Gv3 Reference Manual page 79

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
8. Enter the settings as described in the following table.
Setting
QoS Type
Interface
Service
Direction
Diffserv QoS Match
Priority
Description
From the menu, select Priority.
For information about the Rate Control selection, see
QoS Profile on page 75).
From the menu, select a WAN interface.
From the menu, select a service or application to be covered by this profile. If
the service or application does not appear in the list, you must define it (see
Manage Customized Services
From the menu, select the direction to which the priority queue is applied:
• Outbound Traffic. The priority queue is applied to outbound traffic only.
• Inbound Traffic. The priority queue is applied to inbound traffic only.
Enter a DSCP value in the range of 0 through 63. Packets are classified against
this value. Leave this field blank to disable packet matching.
From the menu, select the priority queue that determines the allocation of
bandwidth:
• Low. All services that are assigned a low-priority queue share 10 percent of
interface bandwidth.
• High. All services that are assigned a high-priority queue share 60 percent
of interface bandwidth.
Note: By default, all services are assigned the medium-priority queue, in which
they share 30 percent of the interface bandwidth.
Configure the IPv4 Internet and WAN Settings
79
Add a Rate Control WAN
on page 282).