Manually Configure A Pppoe Ipv6 Internet Connection - NETGEAR FVS336Gv3 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
The Connection Status screen shows a valid IP address and gateway. You are
connected to the Internet. For more information about the connections status, see
View the WAN Port Status and Terminate or Establish the Internet Connection
page 598.
Note: If the configuration was not successful, see
Connection

Manually Configure a PPPoE IPv6 Internet Connection

To configure a PPPoE IPv6 Internet connection, enter the PPPoE IPv6 information that your
IPv6 ISP gave you. If you do not have this information, contact your IPv6 ISP.
Note: If your ISP requires MAC authentication and another MAC address was
previously registered with your ISP, you must configure that MAC address
on the VPN firewall (see
Firewall

To manually configure a PPPoE IPv6 Internet connection for a WAN interface:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
on page 619.
Change the Advertised MAC Address of the VPN
on page 70) before you begin the following procedure.
Configure the IPv6 Internet and WAN Settings
Troubleshoot the ISP
97
on