NETGEAR FVS336Gv3 Reference Manual page 463

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
192.168.1.100 are assigned to devices on the local network, start the client address
range at 192.168.1.101, or choose an entirely different subnet altogether.
• The VPN tunnel client cannot contact a server on the local network if the VPN tunnel
client's Ethernet interface shares the same IP address as the server or the VPN firewall.
(For example, if your computer has a network interface IP address of 10.0.0.45, you
cannot contact a server on the remote network that also has the IP address 10.0.0.45.)
• Select whether you want to enable full-tunnel or split-tunnel support based on your
bandwidth:
- A full tunnel sends all of the client's traffic across the VPN tunnel.
- A split tunnel sends only traffic that is destined for the local network based on the
specified client routes. All other traffic is sent to the Internet. A split tunnel allows you
to manage bandwidth by reserving the VPN tunnel for local traffic only.
• If you enable split-tunnel support and you assign an entirely different subnet to the VPN
tunnel clients from the subnet that is used by the local network, you must add a client
route to ensure that a VPN tunnel client connects to the local network over the VPN
tunnel.
Configure the Client IPv4 Address Range
The following procedure describes how to define the client IPv4 address range.

To define the client IPv4 address range:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select VPN > SSL VPN > SSL VPN Client.
The SSL VPN Client screen displays the IPv4 settings. The following figure shows an
example.
Set Up Virtual Private Networking with SSL Connections
463