Chapter 6 Virtual Private Networking Using Ipsec And L2Tp Connections; Use The Ipsec Vpn Wizard For Client And Gateway Configurations - NETGEAR ProSafe FVS318N Reference Manual
Prosafe wireless-n 8-port gigabit vpn firewall
Hide thumbs
Also See for ProSafe FVS318N:
- Reference manual (414 pages) ,
- Cli reference manual (297 pages) ,
- User manual (17 pages)
Table of Contents
Advertisement
Virtual Private Networking
6.
Using IPSec and L2TP Connections
This chapter describes how to use the IP security (IPSec) virtual private networking (VPN)
features of the wireless VPN firewall to provide secure, encrypted communications between your
local network and a remote network or computer. The chapter contains the following sections:
•
Use the IPSec VPN Wizard for Client and Gateway Configurations
•
Test the Connection and View Connection and Status Information
•
Manage IPSec VPN Policies
•
Configure Extended Authentication (XAUTH)
•
Assign IPv4 Addresses to Remote Users (Mode Config)
•
Configure Keep-Alives and Dead Peer Detection
•
Configure NetBIOS Bridging with IPSec VPN
•
Configure the L2TP Server
Use the IPSec VPN Wizard for Client and Gateway
Configurations
You can use the IPSec VPN Wizard to configure multiple gateway or client VPN tunnel
policies.
The following sections provide wizard and NETGEAR ProSafe VPN Client software
configuration procedures:
•
Create an IPv4 Gateway-to-Gateway VPN Tunnel with the Wizard
•
Create an IPv6 Gateway-to-Gateway VPN Tunnel with the Wizard
•
Create an IPv4 Client-to-Gateway VPN Tunnel with the Wizard
Note:
Although the wireless VPN firewall supports IPv6, the NETGEAR
ProSafe VPN Client supports IPv4 only; an upcoming release of the
VPN Client will support IPv6.
194
6
on page 195
on page 199
on page 203
Advertisement
Table of Contents
Troubleshooting
