Balancer Shaft; Balancer Shaft Journal Bearing - Suzuki GSX-R750 Service Manual

Hide thumbs Also See for GSX-R750:
Table of Contents

Advertisement

3-62
ENGINE

BALANCER SHAFT

DISASSEMBLY
• Remove the balancer gear along with the dampers from the
balancer shaft.
INSPECTION
• Inspect the damper for wear and damage, replace it if any
defects are found.
REASSEMBLY
• Apply MOLYBDENUM OIL SOLUTION to each part.
 MOLYBDENUM OIL SOLUTION
• Set the dampers and install the balancer shaft to balancer
gear.
NOTE:
* Fit the stopper of the balancer shaft between the dampers.
* Align the line A on the balancer shaft with the punch B on the
balancer gear.

BALANCER SHAFT JOURNAL BEARING

INSPECTION
• Inspect each bearing of upper and middle crankcases for any
damage.
SELECTION
• Place the plastigauge axially along the balancer shaft journal
as shown.
 09900-22301: Plastigauge
Never rotate the balancer shaft when a piece of plasti-
gauge is installed.
• Mate the middle crankcase with the upper crankcase, and
tighten the crankcase bolts (M8) and crankshaft journal bolts
(M9) to the specified torque.
 Crankshaft journal bolt (M9):
Crankcase bolt (M8):
Initial : 18 N·m (1.8 kgf-m, 13.0 lb-ft)
Final : 50°
Initial : 15 N·m (1.5 kgf-m, 11.0 lb-ft)
Final : 26 N·m (2.6 kgf-m, 19.0 lb-ft)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gsx-r600 2006Gsx-r600 20072007 gsxr 6002006 gsxr 600

Table of Contents