J1 Normal Operation; Front Panel Operation - MotoSAT J1 User And Installation Manual

J1 Normal Operation

IMPORTANT! Before the J1 is ready for normal use the system must be wired
and configured correctly. Go to Setup and Configuration for setup.
The J1 Controller can be operated through either Front Panel Controls or via
the HTML Interface built into the Controller.

Front Panel Operation

Model J1
The Front Panel
has three Buttons.
The Power Button is used to turn the J1 Controller On and Off. When Powered
on the Green LED to the Left of the Power Button will illuminate. AC Power
Rocker Switch must be in On "Illuminated" position.
On Power up the controller will take about 15 seconds to initialize. The Power,
LNB, and LAN LED's should be illuminated when controller is ready for use.
Under normal conditions the Stow LED should also be illuminated when first
powered on.
The Search Button will cause the Antenna to rise from the stowed position and
search for the Satellite 1 (Sat 1). See Building, Importing and Exporting a
Config File.
The LNB and GPS lights should be illuminated before the Antenna will start a
Search (move).
Wait for the LNB Light to illuminate before pressing the Select Button. Once
selected the BUSY and READY lights will start to flash.
The dish will begin a search if the GPS Light is on. (GPS Locked)
If the GPS Light is blinking then the Antenna will not move until the GPS Light
goes solid. A blinking GPS means that a valid GPS location has not been
determined. Typically GPS should acquire lock in less than 120 seconds.
8