J1 (System) Wiring; J1 Rear Panel - MotoSAT J1 User And Installation Manual

J1 (System) Wiring

The J1 has Six (6) Connections on the back of the Controller.

J1 Rear Panel

Power > 3 Pin Terminal Block > 12 VDC to 15VDC Input up to 10 Amps.
Antenna > 9 Pin Terminal Block > connects the J1 Controller to the DataStorm
Satellite Antenna usually mounted on the vehicle roof. This connector supplies Motor
Power and Position Information.
Use supplied MotoSAT Antenna Control Cable and wire as shown to the DataStorm
Satellite Antenna Circular Connector (9 or 14 Pin). Only use the supplied cable.
I/O RS232 > 3 Pin Terminal > RS232 Output Only! Outputs a continuous GPS data
stream in NEMA format. Also outputs limited diagnostics.
Bits per second: 4800, Data Bits: 8, Parity: None, Stop Bits: 1, Flow Control: None
Use Cable 406-D9M-SER-T3P.
Example NEMA GPS Data Stream
$GPGGA,152231,4043.0754,N,11157.0855,W,1,05,02.00,001289.1,M,-21.3,M,,*41
$GPGGA,152231,4043.0754,N,11157.0855,W,1,05,02.00,001289.1,M,-21.3,M,,*41
$GPGGA,152231,4043.0754,N,11157.0855,W,1,05,02.00,001289.1,M,-21.3,M,,*41
$GPGGA,152231,4043.0754,N,11157.0855,W,1,05,02.00,001289.1,M,-21.3,M,,*41
Pin 1 Red
Pin 2 Black
Pin 3 N/C
Pin 1 Black
Pin 2 Brown
Pin 3 Red
Pin 4 Orange
Pin 5 Yellow
Pin 6 Green
Pin 7 Blue
Pin 8 White
Pin 9 Purple
+ Volts DC (Positive)
- Volts DC (Negative)
No Connection
AZ Motor - Output
AZ Motor + Output
El Motor + Output
El Motor - Output
Position Count Halt Input
Ground
CAN + Communications
CAN - Communications
UCB Power (+12 to +15 Volts DC)
58