MotoSAT J1 User And Installation Manual page 13

The J1 may find and peak several satellites before identifying a valid satellite.
Once a Reference Satellite is identified the J1 will calculate and move directly to
the Selected Target Satellite.
The J1 will peak the satellite for maximum Signal Quality at that location. After
the peak is completed the J1 will reconfirm the Target Satellite Identification.
NOTE: There are conditions where the Antenna can move into an adjacent
Satellite with a stronger signal level. If this happens the J1 Controller should ID
that Satellite and then move to the Target Satellite as described above.
NOTE: There are two types of Searches available in Search Settings. The
default search is referred to as a Longitude Search. The alternative Search is
referred to as Target Search. We recommend the default setting. See Setup
and Configuration for details.
Search Operation completed the system is ready for use.
System Status Screen Search Complete
13