MotoSAT J1 User And Installation Manual page 74

3. Perform ucbupdate command from the DATASTORM% prompt in a telnet session.
4. Contact MotoSAT support for possible parts replacement.
-13 Compass failure
Future use only
.
-14 Mount SPI failure
Obsolete not used
-15 Mount not present
Issue: Control cable shorted or disconnected Upper control board shorted or disconnect. Internal
wire harness shorted or disconnected.
Resolutions:
1. Power cycle the controller and check connections at the mount and on the controller.
2. Check and reseat connections at the UCU..
3. Using the mounts wiring diagram perform an OHMS test and ensure the system is within
tolerances.
4. Contact MotoSAT support for possible parts replacement.
-16 Tilt sensor failure
Issue:
Resolutions:
1. Power cycle the controller and check connections at the mount and on the controller.
2. Perform nvclear command from the J1boot% prompt in a telnet session power cycle the unit
and reconfigure the controller.
3. Perform ucbupdate command from the DATASTORM% prompt in a telnet session.
4. Contact MotoSAT support for possible parts replacement.
-17 GPS failure
Issue: GPS chip is not sending data.
Temporary solution: Enable Manual location settings in configuration.
Resolutions:
1. Contact MotoSAT support for possible replacement.
-18 Shorted GPS Antenna
F1 mount Trimble Antenna
Issue: GPS antenna is not sending data to the GPS chipset.
Temporary solution: Enable Manual location settings in configuration.
Resolutions:
1. Contact MotoSAT support for possible replacement.
-19 Open GPS Antenna
F1 mount only BRICK UCB
Issue: GPS antenna is not sending data to the GPS chipset
Temporary solution: Enable Manual location settings in configuration.
74