Table of Contents
Advertisement
Check sat table, Config, try other satellite, LNB cables, or controller
Issue: This message should only be displayed in debug mode for use when compiling newer
versions of software if this massage appears during normal use:
Resolutions:
1. Power cycle the controller and check connections at the mount and on the controller.
2. Perform nvclear command from the J1boot% prompt in a telnet session power cycle the unit
and reconfigure the controller.
3. Perform ucbupdate command from the DATASTORM% prompt in a telnet session.
4. Contact MotoSAT support for possible parts replacement.
-58 "Bad motor parameter",
Issue: This message should only be displayed in debug mode for use when compiling newer
versions of software if this massage appears during normal use:
Resolutions:
1. Power cycle the controller and check connections at the mount and on the controller.
2. Perform nvclear command from the J1boot% prompt in a telnet session power cycle the unit
and reconfigure the controller.
3. Perform ucbupdate command from the DATASTORM% prompt in a telnet session.
4. Contact MotoSAT support for possible parts replacement.
-59 Can communication problem
Issue: Can bus error. (UCB to J1 communication error)
Resolution:
1. Ensure the J1 power supply is supplying the correct voltage and amperage for the specific
mount it is controlling.
2. Power cycle the controller and check connections at the mount and on the controller.
3. Perform nvclear command from the J1boot% prompt in a telnet session power cycle the unit
and reconfigure the controller.
4. Perform ucbupdate command from the DATASTORM% prompt in a telnet session.
5. Using the mounts wiring diagram perform an OHMS test and ensure the system is within
tolerances.
6. Contact MotoSAT support for possible parts replacement.
-60 Bad parameter LED
Replace Controller
Issue: This message should only be displayed in debug mode for use when compiling newer
versions of software if this massage appears during normal use:
Resolutions:
1. Power cycle the controller and check connections at the mount and on the controller.
2. Perform nvclear command from the J1boot% prompt in a telnet session power cycle the unit
and reconfigure the controller.
3. Perform ucbupdate command from the DATASTORM% prompt in a telnet session.
4. Contact MotoSAT support for possible parts replacement.
-61 Communications problems with Hughes
Obsolete... call MotoSAT if displayed.
84
Advertisement
Table of Contents
