MotoSAT J1 User And Installation Manual page 23

Config Name
Satellite System
Satellite System sets Modem or ISP type. Setting this value for the proper
modem type will allow the J1 to integrate at different levels with specific
modems.
Currently the J1 shares data with the Hughes Net and iDirect Modems
allowing the J1 to confirm correct Satellite Identification, Signal Quality
level, set TX ranging values, etc.
Other Modems currently displayed in the Satellite System drop down box
function as Generic mode.
Important Note:
mode that many of the following configurations are set correctly. Just
being close will not work.
Satellite Longitude (101W)
Satellite Longitude is a numerical value followed by an E or W. This will
set the Default Satellite (Target Satellite) Location. i.e. 101W
The Bandwidth Provider (VAR) will supply the Satellite Longitude
required for the modem to lock to the correct RF carrier.
When inputting a Satellite Longitude in the western hemisphere you
should place a W after the numerical longitude value.
When inputting a Satellite Longitude in the eastern hemisphere you must
place an E after the numerical longitude value.
If you do not place a W or E after the numerical value the hemisphere will
default to West (W).
Modem LNB
(Default)
(Generic) Setting required
When no modem is connected or does not require
any external input then Generic is recommended.
It is extremely important that when using Hughes Net
Setting required
(LNB A)
23