MotoSAT J1 User And Installation Manual page 20

Config Name
Local Address
The Local Address is the internal Ethernet Address of the J1 Controller.
This address is set at 192.168.1.250 from the factory but can be changed
based on the customer network requirements.
Subnet Mask
Default to 255.255.255.0, see your IT manager if changes to this value are
necessary.
Modem Gateway
This value is set to the modem address. See Modem manual for more
information.
Router Gateway
This value is set to the Router address. If a LAN switch is used then
setting this to the modem address is typical. See Router or Modem
manuals for more information.
DNS Address
This value is set to the modem address. See manuals or white papers for
more information.
Modem Username
If required. Currently the iDirect Modem is the only Modem that requires
a Modem Username to access their Telnet to read SNR (Signal Quality)
and feed it GPS for mobile use. The default Username is admin but the
ISP or VAR can change this. A -25 message will appear on the main
status page if this name is not correct.
Modem Password
If required. Currently the iDirect Modem is the only Modem that requires
a Modem Username and Password to access their Telnet to read SNR
(Signal Quality) and feed it GPS for mobile use. The default Password is
set internally but will display ******** on this screen. Contact the ISP or
VAR if this requires changing. A -25 message will appear on the main
status page if this password is not correct.
(Default)
(192.168.1.250)
(255.255.255.0)
(192.168.1.1)
(192.168.1.1)
(192.168.1.1)
(admin)
(*********) (P@55w0rd!)
Setting required
Setting required
Setting required
Setting required
Setting required
20