Serial Cable (Optional); Power Supply - MotoSAT J1 User And Installation Manual

J1 Serial Cable
NOTE: For Null Modem
reverse pins 2 and 3
this end.
Optional Serial Cable to connect
to and RS232 DTE device.
Satellite Modem Serial Port
2 Cond 22 AWG w/shield Grey

Power Supply

The Power Supply shipped with the J1 Satellite Antenna Controller is dependent on the
Dish Mount used. Most Dish Mounts shipped require 15 Volt DC at 8 Amps. If this is
an upgrade from an earlier version of Antenna Controller, the Power Supply that was
with the system is usable
Part Number: 406-D9M-SER-T3P
Connects to Controller Models
D3, D4, D5, H1, H2, H3, J1
1 Shield
2 Black
3 Natural
Wiring
Strip wires
to 1/8"
1 - Shield - Gnd
2 - Black - RXD
3 - Natural - TXD
5
4
9 Pin D-Sub
3
M ale
2
Connector
Terminal Block Plug
On Shore Technologies
716-EDZ1550-3
Connector
DB 9 Male
Wiring
5 - Shield - Gnd
3 - Natural - RXD
2 - Black - TXD
61