H3 Normal Operation; Front Panel Operation - MotoSAT H3 User And Installation Manual

H3 Normal Operation

IMPORTANT! Before the H3 is ready for normal use the system must be wired
and configured correctly. Go to Setup and Configuration for setup.
The H3 Controller can be operated through either Front Panel Controls or via
the HTML Interface built into the Controller.

Front Panel Operation

Model H3
The Front Panel
has three Buttons.
The Power Button is used to turn the H3 Controller ON and OFF. When
powered ON, the Green LED to the Left of the Power Button will illuminate.
On power up the controller will take about 15 seconds to initialize. The Power,
LNB, and LAN LED's should be illuminated when controller is ready for use.
Under normal conditions the Stow LED should also be illuminated when first
powered on. (After a Calibrate Dish or normal Dish Stow)
The Search Button will cause the Antenna to rise from the stowed position and
search for the Default Satellite. (The Satellite Longitude entered on the Search
Configuration Page.)
When the Search Button is pressed the BUSY and READY lights will start to
flash.
The GPS light should be illuminated (GPS Locked) before the Antenna will start a
Search (move).
If the GPS Light is blinking the Antenna will not move until the GPS Light goes
solid. A blinking GPS means that a valid GPS location has not been
determined. Typically GPS should acquire lock in less than 120 seconds.
NOTE: If GPS is set to Manual then the Dish will begin Search
immediately.
8