MotoSAT J1 User And Installation Manual page 80

User Message
Issue: No error. This message displays when the User hits the Stop command on the
HTML Status Screen.

Refresh HTML Screen

Recycle Power to clear screen.

Contact Technical Support.
-42 Out of memory
Engineering and Development Message
Internal Message Only: This message should only display in debug mode when
compiling newer versions of software. If this massage appears during normal consumer
operation.

Power cycle the controller and check connections at the mount and on the
controller

Perform Telnet NVClear Command and reload Config files.

Perform Telnet UCBupdate command.

Replace J1 Controller
-43 Not supported
Engineering and Development Message
Internal Message Only: This message should only display in debug mode when
compiling newer versions of software. If this massage appears during normal consumer
operation.

Power cycle the controller and check connections at the mount and on the
controller

Perform Telnet NVClear Command and reload Config files.

Perform Telnet UCBupdate command.

Replace J1 Controller
-44 Dish not stowed
Obsolete Message
Issue: This message should only display in earlier versions of J1 Software.

Upgrade to latest version of Software.

Perform Telnet NVClear Command and reload Config files.

Perform Telnet UCBupdate command.
80