Getting Started; Connection And Configuration; Using The Sd Card For Setup; Quick Setup - MotoSAT J1 User And Installation Manual

Getting Started!

If this is a new system install or just upgrading to the new J1 Controller it is
important to follow the guidelines below to insure the system functions properly.

Connection and Configuration!

Nearly all technical support calls on new installations are due to bad or improper
wiring, or incorrect configurations. Please be sure to review these two items
before contacting technical support for assistance.
The J1 must be configured properly before it can be used in normal operation.
Before proceeding insure that all wiring to the J1 Controller is correct. This would
include any connections to the DataStorm Mount. See J1 System Wiring.

Using the SD Card for Setup

The J1 Satellite Antenna Controller includes a Front Panel SD Card Slot. This
feature will allow the user to upgrade firmware, import configuration files, and
import Sat Tables without being connected to a PC or Network. See SD Card
Functions for setup and use.

Quick Setup

Once the System is installed and wired the next step is to prepare the J1 Controller for the
users specific requirements.
Below is a quick list to follow to insure proper operation. Please follow the steps below
in the order as shown.
 Step 1
Set up a Network Connection between the J1 and the PC
Using the SD Card, LoadOnce Folder, place a modified configuration file in the
LoadOnce folder.
Name the file "IPConfig.txt" and place the IP information needed to work in the
existing Network (Router)
LocalAddr = 192.168.1.250
SubnetMask = 255.255.255.0
/new controller IP address
/if different
5