MotoSAT J1 User And Installation Manual page 50

Calibrate Dish
Calibrate Dish (Testdish)
A Calibrate or Test Dish is used to confirm the mechanical performance of the Dish
Mount. This function should be performed after installation of either a new Dish Mount
or Satellite Antenna Controller.
A Test Dish will confirm the Mount Setting Configuration parameters. If the Dish Mount
completes the entire test without errors, the Dish will be in the stowed position and the
HTML page will confirm the Test has passed.
If the Test Dish fails open a telnet session to repeat the test using telnet commands;
DATASTORM % showdebug
DATASTORM % testdish
Capture the entire Test and contact MotoSAT Technical Support for additional
assistance.
Unless a count sensor has failed one of the motor parameters above in mount settings
(
Default Dish Mount Parameters
If any parameters are changed we recommend you export and save the new Configuration
File. If your Satellite Antenna Controller has been replaced these files can be imported
into the new Controller.
) may be modified to allow a successful Test Dish.
Testdish
50