System Error - MotoSAT J1 User And Installation Manual

-3 Bad parameter
Issue: Can bus error. (UCB to J1 communication error)
Resolutions:
1. Power cycle the controller and check connections at the mount and on the controller
2. Perform nvclear command from the J1boot% prompt in a telnet session power cycle the unit
and reconfigure the controller.
3. Perform ucbupdate command from the DATASTORM% prompt in a telnet session.
4. Using the mounts wiring diagram perform an OHMS test and ensure the system is within
tolerances.
5. Contact MotoSAT support for possible parts replacement.
-4 Not ready
Issue: This message should only be displayed in debug mode for use when compiling newer
versions of software if this massage appears during normal use:
Resolutions:
1. Power cycle the controller and check connections at the mount and on the controller.
2. Perform nvclear command from the J1boot% prompt in a telnet session power cycle the unit
and reconfigure the controller.
3. Perform ucbupdate command from the DATASTORM% prompt in a telnet session.
4. Contact MotoSAT support for possible parts replacement.
-5 Bad return value
Issue: This message should only be displayed in debug mode for use when compiling newer
versions of software if this massage appears during normal use:
Resolutions:
1. Power cycle the controller and check connections at the mount and on the controller.
2. Perform nvclear command from the J1boot% prompt in a telnet session power cycle the unit
and reconfigure the controller.
3. Perform ucbupdate command from the DATASTORM% prompt in a telnet session.
4. Contact MotoSAT support for possible parts replacement.
-6 Access denied
Issue: This message should only be displayed in debug mode for use when compiling newer
versions of software if this massage appears during normal use:
Resolutions:
1. Power cycle the controller and check connections at the mount and on the controller.
2. Perform nvclear command from the J1boot% prompt in a telnet session power cycle the unit
and reconfigure the controller.
3. Perform ucbupdate command from the DATASTORM% prompt in a telnet session.
4. Contact MotoSAT support for possible parts replacement.

-7 System error

Issue: This message should only be displayed in debug mode for use when compiling newer
versions of software if this massage appears during normal use:
Resolutions:
72