MotoSAT J1 User And Installation Manual page 41

Skew Stow Position
This value is set by default depending on the Dish
Mount type. Only make adjustments if directed by
MotoSAT Technical Support (800-247-7486)
Skew Stow Position is usually set by default depending on the Dish Mount type.
Making adjustments to this setting without the direction of MotoSAT Technical
Support could cause damage to the Dish Mount or the RF Assembly components
(LNB, BUC, motors...)
This value displays the actual physical location of the Skew Assembly when the
Dish Mount is Stowed.
Default Dish Mount Parameters
The J1 Satellite Antenna Controller will detect what type of Mount is installed. Every
mount has different counts, motor start up torques, running speeds, and limits.
Listed below are the current defaults for each mount. These values may change as
needed in new software versions.
Note: After performing an NVClear and restarting the J1 Controller you can type
"showconfig" in a telnet session to see what the current default settings are for the Dish
Mount connected to the J1 Satellite Antenna Controller.
The default values are listed below for each Dish Mount Type
(determined by Mount Type)
Azimuth, Elevation, and
Skew Motor Parameters
are similar in format but
individual values will
differ in the fields as
shown to the left.
41