MotoSAT J1 User And Installation Manual page 26

Target LNB
Future use only.
Peak Step
Peak Step is the amount of distance in degrees the Antenna Mount will
move to test the signal level/quality during the peaking routines.
The larger the distance between peak steps could speed up the finished
Peak times but might reduce the accuracy of the peak.
The smaller the peak steps may improve the final signal peak but could
slow down final peak times.
Under most conditions 0.33 degrees is a good balance.
Signal Trigger
Signal Trigger is a numerical value that represents a change of Signal
Strength Level during a small period of time. When this value is triggered
the J1 will stop the antenna movement and begin a Signal Identification
Peak.
The Signal Trigger Value is set to Default 5. It can be adjusted from 1 to
40. The lower this value can be set the wider view of the sky for a quicker
search. If this value is set too low the J1 will begin to stop on false targets
such as trees, lights, and buildings. The higher this value is set the
narrower the sky view search angle.
Setting range is 1 to 50.
Trigger Filter
Trigger Filter is the number of consecutive times the Signal Trigger must
see a positive change value before the Antenna Mount will stop to initiate
the peaking routines.
Setting range is 1 to 10.
(LNB A)
(0.33)
(5)
(2)
26