MotoSAT J1 User And Installation Manual page 56

Firmware Upgrade using IP Address 192.168.1.250
While holding down the Search and Stow buttons and then pressing the
Power button and holding both for approximately one second, will cause
the J1 Controller to power up in Boot Mode using a Local IP Address of
192.168.1.250 . This is the Default IP Address of the J1 Controller from
MotoSAT.
Open your Browser to IP Address192.168.1.250. The Upgrade Firmware
Page should open.
Follow steps in HTML Upgrade Firmware above to complete Firmware
Upgrade.
Firmware Upgrade using IP Address 192.168.0.250
While holding down the Stow button and then pressing the Power button
and holding both for approximately one second, will cause the J1
Controller to power up in Boot Mode using a Local IP Address of
192.168.0.250 . This is the Default IP Address of the J1 Controller from
MotoSAT.
Open your Browser to IP Address192.168.0.250. The Upgrade Firmware
Page should open.
Follow steps in HTML Upgrade Firmware above to complete Firmware
Upgrade.
Upgrade Firmware thru SD Card
The J1 Satellite Antenna Controller can also have Firmware Upgraded through the SD
Card Slot.
Load the latest firmware to the SD Card into either the autoload or LoadOnce folder and
place the SD Card into the J1 Controller Card Slot.
Hold down the Search and Stow buttons and then press the Power button and hold for
approximately one second. The J1 will initiate a Firmware Upgrade and the Indicator
lights will scroll from right to left. See Using the SD Card for additional information.
56