MotoSAT J1 User And Installation Manual page 7

Import Web Sat Table allows the user to directly import the latest Satellite Table
File from the MotoSAT Web Site. In Network Settings (Web Sat Table URL) is a
default web address of http://www.motosat.com/sattables/world.csv. This address
can be changed if future sites are available. For this import to work the user must
be connected to an active modem (Network) and locked onto the Satellite.
See Import/Export Files page 52.
 Step 7
Save Configurations and Sat Tables
Once the J1 Controller and Dish Mount have been set up properly the Current Sat
Table and Config Files should be exported.
See Import/Export Files page 52.
After exporting these files to the PC, remove the SD Card from the J1 Card Slot
and connect the SD Card to your PC. Save the Config file and Sat Table to the J1
Files Folder on the SD Card for backup. Place SD Card back into J1 Controller.
The J1 Files Folder is used to store different Firmware versions, and different
Dish Mount configuration files samples. This is just a working folder on the SD
Card. The J1 Controller can not read or write any files to this folder.
7