Stow Dish - MotoSAT J1 User And Installation Manual

Stow the Dish (Stow)
Stowing the Dish puts the antenna back into a travel position where the Antenna
is in a Face Down position on the roof of the vehicle pointing toward the rear of
the vehicle.
Clicking on the Stow button will cause the Antenna to begin the Stow routine.
The System will begin to stow and the J1 Front Panel will show Stow and Busy
Lights flashing. The HTML Status Screen will show Stowing Dish.
The typical stow routine will cause the antenna to first move elevation to a full
back position, then rotate Skew to a correct stow position, then rotate Azimuth
fully counterclockwise, and finish stowing Elevation to a full down position.
When using the Generic mode type in Search Settings, Satellite System the
antenna elevation is moved up above the Satellite Belt first to prevent any
undesired transmissions from hitting any other satellites during stow.
When using specific modems such as iDirect and Hughes (HNS) the J1
Controller has the ability to disable the Transmit function of the Modem.
When these modems are selected in Search Settings, Satellite System the
Antenna will not need to move elevation up before stowing the antenna.
The HTML Screen will show Stow Dish Operation Completed.
System Status Screen Stow Operation Complete
14