Html Operation - MotoSAT J1 User And Installation Manual

HTML (Web Browser) Operation
IMPORTANT! The LAN Light must be on before the web browser can open.
To use the HTML Interface you must access the J1 by using a standard Web
Browser such as Internet Explorer, Netscape, or Mozilla. Open the Browser as
you normally would then type into the address bar the IP Address of the J1
Controller. The default IP address of the J1 is set to 192.168.1.250. This
address can be changed in the Network Settings Screen.
The System Status screen should open if the browser and J1 IP address are
configured correctly. See Setup and Configuration if the page below does not
open.
System Status Screen Antenna Stowed
10