MotoSAT J1 User And Installation Manual page 85

-62 Bad parameter Exchange 1
Replace Controller
Issue: This message should only be displayed in debug mode for use when compiling newer
versions of software if this massage appears during normal use:
Resolutions:
1. Power cycle the controller and check connections at the mount and on the controller.
2. Perform nvclear command from the J1boot% prompt in a telnet session power cycle the unit
and reconfigure the controller.
3. Perform ucbupdate command from the DATASTORM% prompt in a telnet session.
4. Contact MotoSAT support for possible parts replacement.
-63 Bad parameter Exchange 2
Replace Controller
Issue: This message should only be displayed in debug mode for use when compiling newer
versions of software if this massage appears during normal use:
Resolutions:
1. Power cycle the controller and check connections at the mount and on the controller.
2. Perform nvclear command from the J1boot% prompt in a telnet session power cycle the unit
and reconfigure the controller.
3. Perform ucbupdate command from the DATASTORM% prompt in a telnet session.
4. Contact MotoSAT support for possible parts replacement.
-64 Bad parameter Bad Key
Replace Controller
Issue: This message should only be displayed in debug mode for use when compiling newer
versions of software if this massage appears during normal use:
Resolutions:
1. Power cycle the controller and check connections at the mount and on the controller.
2. Perform nvclear command from the J1boot% prompt in a telnet session power cycle the unit
and reconfigure the controller.
3. Perform ucbupdate command from the DATASTORM% prompt in a telnet session.
4. Contact MotoSAT support for possible parts replacement.
-65 Motor stalled elevation
Motor Count issue
Issue: elevation counter is not working properly
Resolutions:
1. Ensure the controller has firmware version 3.9.0 or higher and perform a test dish from the
DATASTORM% prompt.
2. Perform nvclear command from the J1boot% prompt in a telnet session power cycle the unit
and reconfigure the controller.
3. Contact MotoSAT support for possible parts replacement.
85