Table of Contents
Advertisement
SD Card Functions
The SD Card Slot on the J1 Satellite Antenna Controller allows the installer and user a
valuable tool for setup and programming.
For new installs, using this feature will allow the installer the ability to configure the J1
Controller much quicker.
The SD Card comes from MotoSAT with 4 Folders preloaded.
The Autoload Folder is intended to be used by an installer to load the same files multiple
times into different systems with J1 Controllers. This folder will allow one firmware.hex
file, one sattable.csv file, and one config.txt file. (Empty from factory)
The J1 Files Folder is used to store different Firmware versions, and different Dish
Mount configuration files samples. This is just a working folder on the SD Card. The J1
Controller can not read or write any files to this folder.
The LoadOnce Folder is similar to the Autoload Folder with one major difference. After
the LoadOnce Folder has updated the J1 Controller with a file, the J1 will delete that file
from the LoadOnce Folder. So as the name implies "load once". This feature allows the
user to get new Firmware from the MotoSAT Website and place into the LoadOnce
Folder, after it is has updated the J1 it will clear that file from the folder and not try to
accidentally update again. (Empty form factory)
The Manuals Folder will hold any MotoSAT technical manual available for the J1
Satellite Antenna Controller. This is just a technical folder on the SD Card. The J1
Controller can not read or write any files to this folder.
57
Advertisement
Table of Contents
