MotoSAT J1 User And Installation Manual page 37

Mount Settings Page
Note: We recommend whenever possible to make mechanical adjustments to the Dish
Mount before making configuration changes to the J1 Controller. When changes are
made to the J1 Controller for Dish Mount adjustments the customer will be responsible
for insuring the J1 Controller if replaced or NVCleared has re-installed all configurations
necessary for the Dish Mount to function properly.
Config Name
Azimuth Origin
The Azimuth Origin primary function is to center the Dish Mount onto the Roof
Mounting Plate when in the Stowed position.
The F1, F2, and F3 mounts move the Dish Azimuth to a physical current stall at the
Azimuth down limit before allowing the Elevation to move down to the Stowed position.
If the Azimuth current stall position is off by several degrees then it is possible for the RF
Assembly arms to be off centered in the Roof Mounting Plate and actually rest on one of
the rails extending the length of the plate. If this happens the dish will not stow fully
down onto the roof. There are no mechanical adjustments to the mount and Mounting
(Default)
( 0 )
Page 1 of 2
37