Table of Contents
Advertisement
The Stow Button when pressed will move the Antenna to the Travel Position.
When the Antenna is moving to the Stowed position the Busy and Stow Light will
flash. When the Antenna is stowed the Stow Light will be on Solid.
The Front Panel
Power Light
(Green)
AC power Light should also be illuminated.
LNB Light
(Blue)
will illuminate when a Modem is connected to the J1 and
power is applied to the Modem. If the J1 is configured to Generic Mode then the
J1 will supply LNB power.
LAN Light
(Blue)
is illuminated when a network connection is detected.
GPS Light
(Blue)
will illuminate when GPS has received a valid Latitude and
Longitude location. When GPs is not locked LED will Blink.
If there is no GPS (Sensor Board) installed on the Antenna Mount then the GPS
light will be off.
READY Light
(Blue)
peaked.
The Ready Light will flash when the Antenna is searching for a Satellite.
BUSY Light
(Red)
illuminates under many conditions.
On Power Up the Busy light will flash for approximately 15 seconds while the J1
Controller is initializing the system configuration.
During Search and Stow the Busy light will flash.
STOW Light
(Red)
When the Antenna is moving to the stow position the Stow Light will flash.
has seven (7) lights.
is illuminated when ever the J1 is powered on. The Main
will illuminate when the Target Satellite is locked and
is on Solid when the Antenna is Stowed (travel position).
9
Advertisement
Table of Contents
