MotoSAT J1 User And Installation Manual page 30

Dual Verification is used in areas where high RF Reflectivity could cause
the J1 to stop and peak on a reflected RF signals. This is normally in an
area with multi-story steel or glass buildings. When Enabled the J1 must
verify two satellites in the proper orbital locations before completing the
Search Operation.
Note:
Target Search also.
Motion Stow
Motion Stow is initiated when the Tilt (accelerometer) Sensors detect
motion other than mild rocking caused by wind. The J1 Controller must
be powered on for Motion Stow to work.
Note:
been turned on. If the DC Power Supply that runs the J1 is on this AC
Power circuit then Motion Stow will not work.
Inclined Orbit
Inclined Orbit is used when the Target Satellite is constantly moving in a
Vertical Elevation pattern from the determined Clark Orbital slot. To
track this kind of Satellite this configuration must be Enabled.
This mode could also be used in areas where a mount is placed on an
unstable surface such as snow or mud and minimal mount adjustments
may be required.
This routine CAN NOT be used for a vehicle or platform in motion.
Inclined Orbit Angle
The Inclined Orbit Angle is set when the Vertical Change of an Inclined
Orbit Satellite is known.
Inclined Orbit Satellites usually change less than +/- 6 degrees in a vertical
direction. There is a small amount of Azimuth deviation on an Inclined
Orbit Satellite which is also tracked when Inclined Orbit is Enabled.
Manual Location
When Manual Location is Disabled the J1 reads the current location
values (Latitude and Longitude) from the GPS module installed on the
Mount/UCB.
With Dual Verification Enabled it is recommended to Enable
(Disabled)
Some vehicles may disable the AC power when the ignition has
(Disabled)
( 0 )
(Disabled)
30