Lnb Settings - MotoSAT J1 User And Installation Manual

LNB Settings Page
The J1 Satellite Antenna Controller has the ability to use two LNB's to Find, Peak
and Lock to a Target Satellite. Using two LNB's or a Dual LNB that can see
more than one Satellite Band offers the user the ability to Search on one satellite
band and then switch to the other band for the modem to function properly.
A typical Dual Band LNB will have two Local Oscillators which gives the LNB the
ability to see the High or Low Band Ku signals. The oscillator is switched by
using a 22 KHz tone or 13/18Volts. Check the LNB specs for additional
information.
In Search Settings you can choose which LNB to use for searching and which
LNB is needed for the Modem. Sometimes one satellite band has many
satellites to use as a Reference Satellite while the satellite you need to find for
the modem is not common and would be difficult to find if it was the only satellite
to search for.
The LNB Settings Page allows the user to configure the J1 Satellite Antenna
Controller with specific information pertaining to a single or dual LNB setup.
Each Setting is described in detail below.
LNB Settings Page Page 1 of 1
33