MotoSAT J1 User And Installation Manual page 31

When Manual Location is Enabled the J1 will use the values currently
stored in Latitude and Longitude.
Note:
then even if Manual Location is Enabled the values in the Latitude and
Longitude fields will be updated to the current GPS position.
Note:
with GPS not acquiring valid latitude and longitude, the J1 will use the
existing values displayed in Latitude and Longitude and begin a satellite
search. These values may be from a previous location and not valid for
Skew and Ranging information in some modems.
Latitude
Latitude values can be entered manually if GPS is not able to enter valid
data to this field. Even if Manual Location has been Enabled once GPS
acquires valid Latitude data it will overwrite the current value in this field.
Longitude
Longitude values can be entered manually if GPS is not able to deliver
valid data to this field. Even if Manual Location has been Enabled once
GPS acquires valid Longitude data it will overwrite the current value in
this field.
Satellite Selection Sorting Order
Allows two options for the sorting order of the Satellite Selection Drop
Down box on the System Status Page. (Below the Search button)
If valid GPS is ever acquired before a Search command is issued
If a Search command has been initiated and it has been 3 minutes
(Name)
Name sorts the Satellites in the Satellite Selection Drop Down box
into an Alphabetical order.
AMC, Anik, Galaxy ...
Longitude sorts the satellites in the Satellite Selection Drop Down
box into a Longitudal order from West to East.
129W, 127W, 125W, 123W ...
Satellite Selection Drop Down box
31