Sd Card Functions - MotoSAT H3 User And Installation Manual

SD Card Functions

The SD Card Slot on the H3 Satellite Antenna Controller allows the installer and user a
valuable tool for setup and programming.
For new installs, using this feature will allow the installer the ability to configure the H3
Controller much quicker.
The SD Card comes from MotoSAT with 4 Folders preloaded.
The Autoload Folder is intended to be used by an installer to load the same files multiple
times into different systems with H3 Controllers. This folder will allow one
firmware.hex file, one sattable.csv file, and one config.txt file. (Empty from factory)
The H3 Files Folder is used to store different Firmware versions, and different Dish
Mount configuration files samples. This is just a working folder on the SD Card. The
H3 Controller can not read or write any files to this folder.
The LoadOnce Folder is similar to the Autoload Folder with one major difference. After
the LoadOnce Folder has updated the H3 Controller with a file, the H3 will delete that
file from the LoadOnce Folder. So as the name implies "load once". This feature allows
the user to get new Firmware from the MotoSAT Website and place into the LoadOnce
Folder, after it is has updated the H3 it will clear that file from the folder and not try to
accidentally update again. (Empty form factory)
The Manuals Folder will hold any MotoSAT technical manual available for the H3
Satellite Antenna Controller. This is just a technical folder on the SD Card. The H3
Controller can not read or write any files to this folder.
68