Getting Started; Connection And Configuration; Using The Sd Card For Setup; Quick Setup - MotoSAT H3 User And Installation Manual

Getting Started!

If this is a new system install or just upgrading to the new H3 Controller it is
important to follow the guidelines below to insure the system functions properly.

Connection and Configuration!

Nearly all technical support calls on new installations are due to bad or improper
wiring, or incorrect configurations. Please be sure to review these two items
before contacting technical support for assistance.
The H3 must be configured properly before it can be used in normal operation.
Before proceeding insure that all wiring to the H3 Controller is correct. This
would include any connections to the DataStorm Mount. See H3 System
Wiring.

Using the SD Card for Setup

The H3 Satellite Antenna Controller includes a Front Panel SD Card Slot. This
feature will allow the user to upgrade firmware, import configuration files, and
import Sat Tables without being connected to a PC or Network. See SD Card
Functions for setup and use.
Note: A PC with a USB Adaptor or SD slot will be needed to modify the SD Card
Config files.

Quick Setup

Once the System is installed and wired the next step is to prepare the H3 Controller for
the users specific requirements.
Below is a quick list to follow to insure proper operation. Please follow the steps below
in the order as shown.
• Step 1 Set up a Network Connection between the H3 and the PC
Using the SD Card, LoadOnce Folder, place a modified configuration file in the
LoadOnce folder.
Name the file "IPConfig.txt" and place the IP information needed to work in the
existing Network (Router)
5