Customizing Chart Settings; Navigation Page - Standard Horizon CP1000C Owner's Manual

can be changed. The picture below shows the Chart Page with 1 Line Large selected and
a Popup window with many selections.
1. To change a data window field, press and hold [MENU] until the field is highlighted.
2. Move the ShuttlePoint knob to the desired data field and press [ENTER]. The popup
window will be shown.
3. Move the ShuttlePoint knob up or down to choose the desired setting and press
[ENTER] to select and press [CLEAR] to store and exit the editing mode.
Data window field on the NAVIGATION, HIGHWAY, GPS STATUS, and NMEA pages may be
customized in the above manner.
10.1

CUSTOMIZING CHART SETTINGS

1. Press [MENU] and move the Shuttlepoint knob to highlight SETUP and press [ENTER].
2. Move the ShuttlePoint knob to CHART SETUP and press [ENTER].
3. Move the Shuttlepoint knob to CUSTOMIZE CHART and press [ENTER].
4. Move the ShuttlePoint knob up or down to select MARINE SETTINGS, DEPTH
SETTINGS, LAND SETTINGS or CHART SETTINGS and press [ENTER]. See the
above sections for details on selections within each of the settings.
10.2

NAVIGATION PAGE

This page is useful to show information when heading to a destination. The default page is
shown with a Compass Rose, however this can be customized to show a Compass Tape.
1. To change to show the COMPASS TAPE, select the Chart Page, press [MENU] and
move the ShuttlePoint knob to select SETUP and press [ENTER].
2. Move the ShuttlePoint knob to select WINDOW SETUP and press [ENTER].
3. Move the ShuttlePoint to NAVIGATION PAGE and press [ENTER]
4. Move the ShuttlePoint up or down to select COMPASS TAPE and press [ENTER].
Press [CLEAR] or move the Shuttlpoint knob to the right until the Chart Page is shown.
Page 60
Figure 10.0.5 - Customize the Data Windows
NOTE
GPS chartplotters