The Alphanumeric Keys; Getting Started; Power On, Off And Shuttlepoint Knob Operation - Standard Horizon CP500 Owner's Manual

3.0.1

The alphanumeric keys

The 10 alphanumeric keys are used for entering in alphanumeric data.
For alphanumeric input: pressing the key the first time enters the first letter, the second time
it enters the second letter, the third time it enters the third letter; the forth time it enters the
number. After a short time the entered character (letter or number) is confirmed and the
cursor is moved to the next location.
For numeric input: to enter a number in a Lat/Lon: press the key of the number you wish to
enter, continue pressing the numbered keys until the Lat/Lon is entered. The cursor is
moved to the next position. Pressing the ShuttlePoint knob up/down changes the value;
pressing the ShuttlePoint knob left/right moves the cursor to the previous/next location.
3.1

GETTING STARTED

The Getting Started section will take you through the frequently used operations and assist
you to customize the look of the GPS Chart Plotter.
3.1.0

Power On, Off and ShuttlePoint knob operation

1. Press and hold [PWR] until the display shows the Start-Up page (see the following
picture).
To turn Off, press and hold [PWR] until the display turns Off.
2. When the power is first turned on, two pages the Start-Up page and the Caution pages
are briefly shown before the GPS Status page.
Page 22
Figure 3.1.0 - Start-Up page
Figure 3.1.0a - Caution pages
CP500