7510-XXX
Bridge unit diverter gate removal
1. Remove the bridge unit assembly. See
2. Remove the bridge unit left cover. See
3. Remove the bridge unit diverter gate solenoid. See
page
4-14.
4. Gently pull the bridge unit diverter gate (A) out of the assembly.
5. Remove the bridge unit diverter gate (A).
Bridge unit bin media exit solenoid removal
1. Remove the bridge unit assembly. See
2. Remove the bridge unit left cover. See
3. Remove the three screws securing the bracket (A) to the assembly.
4. Remove the bracket (A) from the assembly.
5. Remove the screw securing the plastic cover (B) to the assembly.
6. Remove the plastic cover (B).
7. Remove the E-clip securing the Bridge unit bin media exit solenoid (C) to the shaft.
8. Remove the two screws securing the Bridge unit bin media exit solenoid (C) to the assembly.
9. Remove the Bridge unit bin media exit solenoid (C).
4-16
MFP Finisher Service Manual
"Bridge unit assembly removal" on page
"Bridge unit left cover removal" on page
"Bridge unit diverter gate solenoid removal" on
"Bridge unit assembly removal" on page
"Bridge unit left cover removal" on page
4-5.
4-17.
4-5.
4-17.