Bridge Unit Diverter Gate Solenoid Removal - Lexmark X940e Service Manual

7510-XXX
7. Remove the sensor (bridge unit bin exit) (B).

Bridge unit diverter gate solenoid removal

1. Remove the bridge unit assembly. See
2. Remove the bridge unit left cover. See
3. Disconnect the connector from the bridge unit diverter gate solenoid (A).
4. Disconnect the connector from the switch (bridge unit top cover interlock) (B).
5. Release the harnesses from clamps.
6. Remove the two screws securing the plastic cover (C) to the assembly.
7. Remove the plastic cover (C).
8. Remove the two screws securing the bridge unit diverter gate solenoid (A) to the assembly.
4-14
MFP Finisher Service Manual
"Bridge unit assembly removal" on page
"Bridge unit left cover removal" on page
4-5.
4-17.