7510-XXX
Removal procedures
Remove the power cord from the electrical outlet before you connect or disconnect any cable
or electronic board or assembly for personal safety and to prevent damage. Disconnect any
connections between the printer and PCs/peripherals.
Note: Some removal procedures require removing cable ties. You must replace cable ties during reassembly
to avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
Note: Parts are controlled as spare parts. When servicing parts for which no procedure is described, observe
the assembly before starting the service.
Note: Though the optional parts are assumed to be removed, they may not be removed if not required for the
purpose of service.
Before starting service work
•
Turn the power off, and remove the power cord from the outlet.
•
While performing service around the fuser assembly, ensure the fuser area has cooled down.
•
Do not use excessive force to remove parts. Damage to the parts or function of the machine may occur.
•
A wide variety of screws are used; make note of their positions during service.
•
Wear a wrist band to remove the risk of static electricity.
4-2
MFP Finisher Service Manual
CAUTION