Sub Paddle Drive Shaft Assembly Removal - Lexmark X940e Service Manual

Sub paddle drive shaft assembly removal

1. Open the finisher front door assembly.
2. Remove the rear upper cover. See
3. Remove the media eject unit assembly. See
4. Loosen the screw securing the knob (A) to the sub paddle drive shaft assembly (B) on the front of the finisher.
5. Remove the knob (A).
6. Remove the one e-clip securing the sub paddle drive shaft assembly (B).
7. Remove the bushing (C).
"Rear upper cover removal" on page
"Media eject unit assembly removal" on page
Front
4-23.
B
C
E-clip
Screw
A
Repair information
7510-XXX
4-58.
4-63