7510-XXX
5. Release the hooks securing the sensor (bridge unit media entrance) (C) to the bracket (A).
6. Remove the sensor (bridge unit media entrance) (C).
Sensor (bridge unit media exit) removal
1. Remove the bridge unit assembly. See
2. Remove the bridge unit right cover. See
3. Place the bridge unit upside down.
4. Remove two screws securing the bracket (A) to the bridge unit (B).
5. Disconnect the connector from the sensor (bridge unit media exit) (C).
6. Release the hooks securing the sensor (bridge unit media exit) (C) to the bracket (A).
4-12
MFP Finisher Service Manual
"Bridge unit assembly removal" on page
"Bridge unit right cover removal" on page
4-5.
4-11.