7510-XXX
5. Remove sensor (booklet end guide HP) (A).
Booklet media pinch roll assembly removal
1. Remove the booklet unit assembly. See
2. Remove the Sensor (booklet unit media entrance). See
on page
4-137.
3. Remove the four screws securing the frame X from the booklet unit assembly.
4. Release the cable harness from the frame X.
5. Remove the booklet unit front door assembly. See
page
4-137.
6. Remove the four screws securing the booklet media pinch roll assembly (A) from the booklet unit assembly.
4-140
MFP Finisher Service Manual
Left
Connector
A
"Booklet unit assembly removal" on page
"Sensor (booklet unit media entrance) removal"
"Booklet unit front door assembly removal" on
4-121.